ZAGG invisibleSHIELD Discussion
I just applied the dreaded "wet" Invisible Shield brand to my wife's DInc. If you're super paranoid about the liquid seeping, try this:
-Wear *NON POWDERED* latex exam gloves. These will help prevent fingerprints as your handle the device and the protector. The instructions say to wash your hands, but I prefer the added protection of the gloves.
-Apply the spray to the protector as instructed (both sides!).
-Position the protector.
-Once positioned, hold a dry microfiber cloth at the edge of the protector.
-Squeegee in the direction of the microfiber cloth. Reposition and repeat around the device, sopping up excess moisture with the cloth before it has a chance to find its way into the cracks and crevices of your phone.
I tried this method first with my boss's iPad and perfected it on my wife's DInc. After a day or two all the tiny bubbles work their way out and the protector is barely noticeable. I'll be using an Invisible Shield screen protector on my DX. They're a little bit more pricey than other offerings, but from my experience they are well worth the extra few bucks."In the beginning the Universe was created. This has made a lot of people very angry and has been widely regarded as a bad move." ~ D.N.A.
- 07-11-2010, 08:44 PM #2
- 07-11-2010, 09:04 PM #3
- 07-11-2010, 09:05 PM #4
- 07-11-2010, 09:15 PM #6
- 07-11-2010, 10:18 PM #7
- 07-11-2010, 10:51 PM #8
I would think so. The IS is basically a thin layer of plastic you put over some or all of the phone. I prefer using their screen protectors in conjunction with a case. On the DInc I ordered a Seidio Innocase II Surface and the combination of the two is providing excellent coverage. I have no experience trying to put a case over a full coverage IS application, but seeing as it is so thin, I don't see an issue with layering up and using it as a final barrier of protection."In the beginning the Universe was created. This has made a lot of people very angry and has been widely regarded as a bad move." ~ D.N.A.
- 07-12-2010, 12:41 AM #10
I think I'm going to get just a basic screen protector, then a silicone case and call it done, but I'm still not sure yet...Kyocera Strobe> Motorola Razor> Motorola Q> Blackberry Curve> Droid X> Fascinate
My father got my Droid X, my stepmother has a Droid 2, and I'm using a rooted Fascinate, swapping out lots of roms.
- 07-12-2010, 12:55 AM #11
- 60 Posts
This invisible shield is apparently made of the same stuff they used to put on the blades of military helicopters to protect them from various nicks and scrapes. I dig it.
Already pre-ordered one for the X. No brainer.Droid X
- 07-12-2010, 09:11 AM #12
- 16 Posts
I've had an IS on my Storm 1 (yea yea I know, ugh) since almost day one, which was launch date. I got the full body coverage skin. I must say, it's protected the phone very well, but within a couple of weeks I did notice that the edges near curved parts of the phone were coming up juuuuust a hair and dust would accumulate there. I got kinda used to it and it wasn't actually until about 3 weeks ago that I finally had enough and took the two pieces off that covered the curved sides of the Storm. The screen portion of it, however, has been a totally different story. Not even a hint at peeling up. It's been phenomenal. I have already pre-ordered one for the X but stuck with just the screen. Zagg's products are top notch in my book. ::thumbs up::
- 07-12-2010, 01:15 PM #13
- 60 Posts
- 07-12-2010, 01:25 PM #14
The IS's will peel at the corners if you don't get the case, etc. over top of the edges of the screen protector. I love them. They will give you the orange peel effect on the non screen portions, so I only use screen protection and don't notice a difference in phone usage.
- 07-12-2010, 02:24 PM #15
- 07-12-2010, 02:26 PM #16
Nah....sticking with my incredible.
Brother had the option to get the X and decided to wait it out and he got the Inc on friday. Hasn't stopped playing with it. He said the X was way too big and the resolution was slightly different.
- 07-12-2010, 02:27 PM #17
- 07-12-2010, 03:41 PM #18
- 07-12-2010, 03:46 PM #19
Galaxy Nexus ^_^
- 452 Posts
- 07-13-2010, 08:05 AM #20
- 143 Posts
I think I will be rolling with the InvisiShield by Zagg. They are taking Pre-orders for the DX online.
I am ususing on my iPad and love it. I was nervous about wet application myself, but just work slowly and it is a piece of cake.
I would highly recommend spending the few extra bucks.
- "In the beginning the Universe was created. This has made a lot of people very angry and has been widely regarded as a bad move." ~ D.N.A.
- 07-14-2010, 04:13 AM #22
- 48 Posts
I've used the Skinomi screen protectors on my Storm, Eris and now soon I'll be getting my Droid X! They have never yellowed or cracked, and I've even transferred one from one Eris to another and it still worked great!
Amazon.com: Skinomi TechSkin - Invisible Screen Protector Shield for Motorola Droid + LIFETIME REPLACEMENTS: Cell Phones & Service
- 07-15-2010, 04:52 PM #24Retired Moderator
- 1,214 Posts
Got my ZAGG when I bought mine at Best Buy today. Just installed a little bit ago. I love the no fingerprints and it feels very nice.
- 07-15-2010, 08:40 PM #25