[chrisjcks]

Hey guys,

Following my : (which I also posted here on AC forums too)

I decided to stick with them and go for the screen protector only, as i dont require the full body on this tablet.

ive had the Skin on for only a couple of days, and its already looking pretty close to perfect right about now.

things to know:

• Wet screen protectors will always produce some Orange-Peel-effect, even if they say they dont - however, ive found BestSkinsEver to be significantly less than ie. Zagg's Invisible Shield, Bodyguardz, Skinomi etc

• Touch Sensivity is the same, as seen the video.

• Swiping has little drag as with any protector, it will never be as good as the naked glass screen, but VERY little.

Installation Tips:

• Use large bowl of warm water, add 1 drop of washing up liquid and rinse bowl until all soap has vanished

• Soak your fingers in this water before peeling off the protector from its backing to prevent fingerprints.

• Peel it off & soak the damn thing, shake off the excess before applying.

• Align skin completely before using the card/squeegee method of removing the water underneath.

• Grab a card, if possible wrap once in a microfibre cloth to prevent damage (not essential, just recommended)

• Squeegee from the middle outwards, and only Lightly press - use the side of the card, never the corners.

• If you need to re-lift the skin to re-apply, completely remove it slowly to avoid stretching and soak in the water again. (remember - wet fingers)

Good Luck, All the best.

Video:



Pictures:

[Jeremy8000]

Nice images, good clean install. I had, in my opinion, the same results with ArmorSuit. Completely bubble-free, super simple to align perfectly, glassy feel, no observable 'peel' effect.

One thing I notice as a difference about the one you used: while there is a cutout for the camera, the skin actually covers over the light sensor that is immediately to its right (I noticed that at 0:25 in the video). I don't know that it would have any impact, but thought I'd point it out.

[chrisjcks]

Nice images, good clean install. I had, in my opinion, the same results with ArmorSuit. Completely bubble-free, super simple to align perfectly, glassy feel, no observable 'peel' effect.

One thing I notice as a difference about the one you used: while there is a cutout for the camera, the skin actually covers over the light sensor that is immediately to its right (I noticed that at 0:25 in the video). I don't know that it would have any impact, but thought I'd point it out.

Makes absolutely no difference that the light sensor is covered.

Same for the HTC ONE X skin.

Sent from my HTC One X using Tapatalk 2

[Jeremy8000]

Thanks - good to know. It's also a bit less expensive than the ArmorSuit - I might give them a try next time I need to shield a device.

[chrisjcks]

Thanks - good to know. It's also a bit less expensive than the ArmorSuit - I might give them a try next time I need to shield a device.

Little birdy tells me there will be a discount from Monday 6th - Wednesday 8th August.

It will be 25% off everything.

Sent from my HTC One X using Tapatalk 2