Help with charging times (bumblebee 2.4)

cybermaniak

Well-known member
Feb 21, 2011
77
2
0
Visit site
Hey guys I?m using Bumblebee 2.4 and its?s taking a lot time to charge.

I have been watching carefully and 1 percent is taking around 6 minutes, that would be 600 minutes to charge a 0-100% = 10 hours ....

It?s this normal ??

when I was on stock rom (rooted only) it didn?t take that long...

I have 3 cables and with all three is the same..

Any clue ?
 

Kreatur3

Well-known member
Mar 2, 2011
660
40
0
Visit site
Hey guys I?m using Bumblebee 2.4 and its?s taking a lot time to charge.

I have been watching carefully and 1 percent is taking around 6 minutes, that would be 600 minutes to charge a 0-100% = 10 hours ....

It?s this normal ??

when I was on stock rom (rooted only) it didn?t take that long...

I have 3 cables and with all three is the same..

Any clue ?

Either your battery is crap or you need to recalibrate your battery.
 

israelsalinas14

Well-known member
Jun 17, 2011
188
3
0
Visit site
I'm on bumblebee 2.4 and it only takes about 2.5 hours to fully charge when I dont use it. But when I use it as its charging, it can take really long.
 

Kreatur3

Well-known member
Mar 2, 2011
660
40
0
Visit site
This problem only started when I did the rom change.. How to recalibrate the battery ?

Go into recovery and wipe your battery stats, should be under advanced where wiping dalvik is.
I haven't used bb2.4 since I started testing ath3nos but it never took nearly that long to charge my battery.
 

cybermaniak

Well-known member
Feb 21, 2011
77
2
0
Visit site
Go into recovery and wipe your battery stats, should be under advanced where wiping dalvik is.
I haven't used bb2.4 since I started testing ath3nos but it never took nearly that long to charge my battery.

Thanks.. and that could be done either if its not fully charged ? only plugged to the wall ?
 

cybermaniak

Well-known member
Feb 21, 2011
77
2
0
Visit site
Found some instrucctions... is this correct ?

Charge to 100%
Clean batterystats (from recovery mode)
use the phone until the battery is dead (the phone turn off)
and charge again.. (with out touching the phone)
 

Kreatur3

Well-known member
Mar 2, 2011
660
40
0
Visit site
Found some instrucctions... is this correct ?

Charge to 100%
Clean batterystats (from recovery mode)
use the phone until the battery is dead (the phone turn off)
and charge again.. (with out touching the phone)

Yeah, I would just do those steps and then see how it goes.
Could also be a problem with the install you did so if that doesn't help I would try doing a fresh flash and remember to wipe everything.