| || |
Re: Spigen Neo Hybrid case delivered today
I totally hear ya! I did not have the phone in the case when I did it. I sat at the kitchen table - well lighted from above - and then wet dusted the area.
Originally Posted by felloffthetruck
I opened the package and then cleaned the prints off the phone screen. Being under the light was very helpful - little specks of dust were visible. I wiped those away - first with the alcohol wipe, then with the microfiber cloth provided. I took Film #1 off (and was lucky to not have any dust adhere to that), checked for dust again with the microfiber cloth, and turned the glass over the phone immediately. I did my 'fitting' very close to the surface of the phone, so as to limit my dust collection. Then I just placed it down carefully.
I didn't have any major air pockets, though there were a few places where it looked like the glass was not fully adhered to the screen. In these spots, I pressed down and moved my fingers from the center to the edge - after a bit they went away.
I'm lucky I didn't have any dust under the glass...but I think the trick is to do it in a clean area.