1. Jamezcua's Avatar
    The bezel around the charging port of my incredible just came loose! Has this happened to anyone? I haven't dropped my phone or anything. It's just loose and it rattles when I use my phone. But it still charges. Any ideas or is it just poor chraftsmanship?
    06-16-2011 05:57 PM
  2. el viejo's Avatar
    I've had my phone for three+ weeks now and that has not happened. However, I have been concerned that it might since the micro usb plug is very hard to insert and remove. Would be interested to know if anyone has "lubricated" the plug to help minimize this problem.
    06-17-2011 07:23 AM
  3. mmaaddict78's Avatar
    My entire usb port has begun to get loose. If I plug a usb cable into my phone I can wiggle the plug and the port moves. I hope it doesn't get much worse.
    07-08-2011 10:57 AM
  4. PhiPsi32's Avatar
    I get a lot of "wiggle & jiggle" when plugged in. Thankfully, I only plug in at night. Otherwise, battery swap during the day. I wouldn't worry as long as you are not having any problems charging or syncing. If the housing moves around handling the phone, consider a warranty exchange.
    07-10-2011 08:08 PM
  5. initech_milton's Avatar
    I have had the HTC Incredible 2 phone only for 4 days and the black "insert" around the usb connector port has become loose. It rattles a lot. I suspect the thing is nothing but a protective frame for the usb port. In my case, I also noticed the back cover around that area (lower left corner) is a bit loose. And like another person pointed out the connector is very tight (easy to plug in but very hard to pull out). I have to say it's very annoying for a brand new phone even if it deosn't cause any functional problems. For a lot of people this probably is not going to be an issue but I happen to be one of those people who would take a wrench and tighten up every nut and bolt on everything. I think you can probably fix the problem by dabbing very small amount of super glue around the black frame
    07-10-2011 11:13 PM
  6. mmaaddict78's Avatar
    Super glue has a tendency to melt plastic. If anything, maybe a bit of apoxy would do the trick.
    07-11-2011 07:32 PM
  7. brandonx1000's Avatar
    after doing some research, i found that the micro usb plug isn't actually attached to the board like other phones, just a ribbon...a teardown picture shows it

    http://www.repairlaunch.com/wp-conte...-4-500x193.jpg
    07-24-2011 07:03 PM
  8. dbdynsty25's Avatar
    Yeah, I just dabbed a very slight amount of super glue...all of the rattling and movement is gone now. And it didn't melt it either. It literally was one little drop...that's all it needed.
    07-25-2011 06:17 PM
LINK TO POST COPIED TO CLIPBOARD