1. n0m0n's Avatar
    Hello,
    I downloaded PandaHome and was wondering if anyone know if there was a way to make it easier to set height width values?

    I wanted to set the top right, center right tabs to 300, (both) but its impossible to set the values to an exactly #.
    Very frustrating.

    Maybe I don't have a steady enough hand but I stop at 300 and its 314, 297, and so on.,
    Since they are located on the same side and when each is open I would like to have then look exact , nice and neat..
    Please advise
    Thanks
    JW
    01-13-2010 11:11 AM
  2. Nechasin's Avatar
    I don't know of an easy way to do it. It is a PITA. What I do is get close, and then roll my finger to fine tune the adjustment.
    01-13-2010 12:45 PM
LINK TO POST COPIED TO CLIPBOARD