1. brainstewn's Avatar
    I have a main router (Cisco E2000) and a Ubiquiti AP WAP integrated 70 feet away from the E2000. The apple iPhone 4s I used to carry switched wonderfully between these two (I think based on signal strength). With the G3 I'm having to manually connect between the two connections to get the best signal and speed. Is there a setting to make this happen automatically?
    08-13-2014 09:46 AM
  2. koroshiyax's Avatar
    I was looking for this setting as well, and unfortunately I haven't found it yet. I came from a BlackBerry 10 which had a feature called "Inter-Access Point Handover" and always looks for the stronger signal when the SSID is the same.

    I too have two APs in my home, as it is quite large, both have the same SSID but are on different channels. When I walk from AP1 to AP2, even when I'm right next to AP2 it won't connect to it automatically, and only would if it loses the connection compleletely from AP1.

    I'm hopeful it is just a software/driver issue. I know laptops have that feature as well, at least with Intel chipsets.
    08-13-2014 10:07 AM

Similar Threads

  1. Replies: 2
    Last Post: 08-21-2015, 02:35 AM
  2. Lookout not backing up contacts on Sony M2
    By AC Question in forum Ask a Question
    Replies: 3
    Last Post: 08-15-2014, 12:19 AM
  3. my tablet does not read a usb flash drive
    By AC Question in forum Ask a Question
    Replies: 1
    Last Post: 08-13-2014, 11:51 AM
  4. Replies: 1
    Last Post: 08-13-2014, 08:41 AM
  5. Wifi & bluetooth not working! Toggles back!
    By AC Question in forum Ask a Question
    Replies: 1
    Last Post: 08-12-2014, 11:49 PM