Custom Size Screen Protector

[Hermes Hidayat]

So i was thinking of a custom size screen protector for my N20U. Like 2cm less on left and right(leaving the curve naked) and 1cm less on the top and bottom.

Anybody done this before?

Rhinoshield Impact Flex(cut off around 1cm-1.5cm)

 

[donm527]

So i was thinking of a custom size screen protector for my N20U. Like 2cm less on left and right(leaving the curve naked) and 1cm less on the top and bottom.

Anybody done this before?

Just wondering why? As for sides I probably wouldn't have minded if someone made a tempered and didn't go around the curved sides if it meant a flat piece of glass that was fully adhedsive like you get on iPhones.

 

[Hermes Hidayat]

Just wondering why? As for sides I probably wouldn't have minded if someone made a tempered and didn't go around the curved sides if it meant a flat piece of glass that was fully adhedsive like you get on iPhones.

i found it already(actually did a little DIY by myself)

as for the reason is that i was afraid that putting a case on is gonna mess the screen protector.

i applied the Rhinoshield Impact Flex perfectly aligned,put my phone back into the case and the top lifted.so i just use a precision cutter to cut the top off and it seems good now.But i scratched my screen.good job GG Victus.

 

[Mandarita]

I think those measurements of 2 cm and 1 cm would make it hard to use the S-Pen on the phone. I would have a bump where it ends that would interfere with my writing. Currently, my screen protector comes just short of the edges and it works fine and doesn't pop off. I think I would rather change my case than have a strange bump almost an inch in from the edge of my screen.

That being said, I wouldn't mind one that stopped just short of the curves to allow for an easy install and not having to do the Whitestone Dome. Literally being able to easy install a flat piece of glass like all the other phones would be nice. But, I would want it to go just short of that curve, not 2 cm in.

 

[Hermes Hidayat]

I think those measurements of 2 cm and 1 cm would make it hard to use the S-Pen on the phone. I would have a bump where it ends that would interfere with my writing. Currently, my screen protector comes just short of the edges and it works fine and doesn't pop off. I think I would rather change my case than have a strange bump almost an inch in from the edge of my screen.

That being said, I wouldn't mind one that stopped just short of the curves to allow for an easy install and not having to do the Whitestone Dome. Literally being able to easy install a flat piece of glass like all the other phones would be nice. But, I would want it to go just short of that curve, not 2 cm in.

yes,thats what i meant.not actually 2cm but smaller sized protectors.there used to be a lot for the s10 seris(full or cropped)but there arent any for the N20U.

but my DIY Rhinoshield does the job well enough,leaving the top naked(about 2cm)