Avid runner frustrated with Gear S (been deliberating s health vs Nike)- s health gives inaccurate splits, and poor map color coding in stats afterwards while Nike plus stats are unreadable while running (red ticker tape at bottom) AND sometimes gps kicks in at 0.25 miles in run. Well I think I have found a work around.
Lotta steps but really easy.
1) will be using nike plus app for run
2) make sure watch fully charged
3) disconnect phone and watch from each other using gear app (watch in standalone)
4) on watch turn off gear network-ie set to always off- (this auto turns off mobile network)
5) (revelation)- go to accessibility under settings on watch and turn on "invert colors" this makes Nike app stats (formerly dark red) HIGHLY visible during run-watc will be flaming white colors
6) turn off all motions (ie so when you lift up watch nothing happens)
7) allow at least 15 second auto screen off time or even 30 seconds - 10s (default) is too short while running to see scrolling stats.
Because of 6 above, I press button to turn on watch and take a peak while running, and then hit button again to turn off - this saves battery as well because with motion activated to turn on watch, I believe watch is often being triggered on and you don't know it.
8) connect Bluetooth headset if you wish
9) first turn on s health and pause pedometer...(battery saver)
10) then go to "run"on s health and start a run! This will activate and lock GPS (takes about 1 minute)....once run starts GPS is locked....immediately end the run. Now, clear all active apps. Start your music through Samsung music player (as Nike doesn't shuffle).
10) now open Nike app and start run...click "no" to music (already playing)..because you did the fake run with s health, you'll notice gos turns green 2 seconds into run (otherwise takes a minute into run).
Getting good battery life. Should be adequate for half marathon/2 hours
Lotta steps but really easy.
1) will be using nike plus app for run
2) make sure watch fully charged
3) disconnect phone and watch from each other using gear app (watch in standalone)
4) on watch turn off gear network-ie set to always off- (this auto turns off mobile network)
5) (revelation)- go to accessibility under settings on watch and turn on "invert colors" this makes Nike app stats (formerly dark red) HIGHLY visible during run-watc will be flaming white colors
6) turn off all motions (ie so when you lift up watch nothing happens)
7) allow at least 15 second auto screen off time or even 30 seconds - 10s (default) is too short while running to see scrolling stats.
Because of 6 above, I press button to turn on watch and take a peak while running, and then hit button again to turn off - this saves battery as well because with motion activated to turn on watch, I believe watch is often being triggered on and you don't know it.
8) connect Bluetooth headset if you wish
9) first turn on s health and pause pedometer...(battery saver)
10) then go to "run"on s health and start a run! This will activate and lock GPS (takes about 1 minute)....once run starts GPS is locked....immediately end the run. Now, clear all active apps. Start your music through Samsung music player (as Nike doesn't shuffle).
10) now open Nike app and start run...click "no" to music (already playing)..because you did the fake run with s health, you'll notice gos turns green 2 seconds into run (otherwise takes a minute into run).
Getting good battery life. Should be adequate for half marathon/2 hours
Facebook
Twitter
Instagram