My tribute to carbon ***Updated** 56k Stay Away lol
**UPDATED**
My tribute to Hrshycro
He gave me the inspiration, insight and pointed me in the right direction. I think the Incredible is a little harder because of the multiple steps(as in different heights in the battery door).
~Sorry some of the pictures I didn't adjust APTR so the focus is very centered and very bokha~
Step 1: Supplies
- X-Acto Knife kit with a High Quality Number 11 blade (precision cuts) and a Number 5 blade(cutting less delicate parts).
- Alcohol wipes (or cotton ball with Rubbing Alcohol) to clean off grease and finger prints.
-Microfiber wipe
- Marker, gel pen & mechanical pencil
- Di-Noc Carbon Fiber 3M Material HERE
-Heat gun (blow dryer works also just not as well)
- Primer 94 by 3M, bonding material so that the Di-Noc sticks better.
Step 2:
Tracing a Pattern
First with the inside of the battery door facing down on top of the material take a black marker and mark the center of the camera hole.
Then take the battery door out of the way and use your mechanical pencil to indent the material so that when you flip i over you can see where the center of the opening will be.
This way when you flip it over you know how to align your door for tracing.
Once that is done flip the material over (white side up) and place the outside of the battery door face down on the material. Go ahead and line up that divot or indent as best as you can with the center of the camera hole.
Mark out a cross in that hole and use your marker to fill in the flash holes and the speaker phone hole. See this larger picture(s) for reference:
**UPDATED**
My tribute to Hrshycro
He gave me the inspiration, insight and pointed me in the right direction. I think the Incredible is a little harder because of the multiple steps(as in different heights in the battery door).
~Sorry some of the pictures I didn't adjust APTR so the focus is very centered and very bokha~
Step 1: Supplies
- X-Acto Knife kit with a High Quality Number 11 blade (precision cuts) and a Number 5 blade(cutting less delicate parts).
- Alcohol wipes (or cotton ball with Rubbing Alcohol) to clean off grease and finger prints.
-Microfiber wipe
- Marker, gel pen & mechanical pencil
- Di-Noc Carbon Fiber 3M Material HERE
-Heat gun (blow dryer works also just not as well)
- Primer 94 by 3M, bonding material so that the Di-Noc sticks better.
Step 2:
Tracing a Pattern
First with the inside of the battery door facing down on top of the material take a black marker and mark the center of the camera hole.
Then take the battery door out of the way and use your mechanical pencil to indent the material so that when you flip i over you can see where the center of the opening will be.
This way when you flip it over you know how to align your door for tracing.
Once that is done flip the material over (white side up) and place the outside of the battery door face down on the material. Go ahead and line up that divot or indent as best as you can with the center of the camera hole.
Mark out a cross in that hole and use your marker to fill in the flash holes and the speaker phone hole. See this larger picture(s) for reference:
Last edited: