This ROM requires that ClockworkMod Recovery already be installed on your phone. If you do not have Clockwork already, please use this method instead.
The installation instructions on XDA are a short-hand version as of this writing - if you need a full step-by-step, see below.
Source: [ROM][ACS] Froyo Build DK28 - Deodex/Rooted - NO DI18 NEEDED - PROTECTED APPS - 12/4 - xda-developers
Features
New Modem
Deodexed
Zipaligned
Pre-Rooted
Instructions
Note: the following work with Windows only (there is no version of Odin for Linux or OSX)
Step 1. Boot your phone into download mode by powering off your phone holding "1" on the keyboard and holding power until you see a picture of an android digging.
Step 2. Extract "dk28-odin-modem.zip" onto your computer, then launch "Odin3+v1.61.exe". Press the "PIT" button and select "victory_8G_100528.pit", then press the "PDA" button and select "modem.tar".
Step 3. On the left side of the Odin screen, make sure only "Auto Reboot" is checked.
Step 4. Plug in the usb cable (if it's done right you should see a yellow Com device light up in one of the rectangular boxes).
Step 5. Click Start and wait until you get a green box at the top that says success. Your phone should reboot. To confirm this worked (optional), you can go to Settings>About phone and it should read under Baseband version "S700.0.5S.DK28".
Step 6. Place "acs-dk28-signed.zip" on your SD card. Boot into Clockwork.
Step 7. Do a factory reset/wipe 2 times, and wipe the cache 2 times.
Step 8. Flash the ROM by going to install zip from SD card in Clockwork and finding/selecting "acs-dk28-signed.zip".
Step 9. Enjoy!
The installation instructions on XDA are a short-hand version as of this writing - if you need a full step-by-step, see below.
Source: [ROM][ACS] Froyo Build DK28 - Deodex/Rooted - NO DI18 NEEDED - PROTECTED APPS - 12/4 - xda-developers
Features
New Modem
Deodexed
Zipaligned
Pre-Rooted
Instructions
Note: the following work with Windows only (there is no version of Odin for Linux or OSX)
Step 1. Boot your phone into download mode by powering off your phone holding "1" on the keyboard and holding power until you see a picture of an android digging.
Step 2. Extract "dk28-odin-modem.zip" onto your computer, then launch "Odin3+v1.61.exe". Press the "PIT" button and select "victory_8G_100528.pit", then press the "PDA" button and select "modem.tar".
Step 3. On the left side of the Odin screen, make sure only "Auto Reboot" is checked.
Step 4. Plug in the usb cable (if it's done right you should see a yellow Com device light up in one of the rectangular boxes).
Step 5. Click Start and wait until you get a green box at the top that says success. Your phone should reboot. To confirm this worked (optional), you can go to Settings>About phone and it should read under Baseband version "S700.0.5S.DK28".
Step 6. Place "acs-dk28-signed.zip" on your SD card. Boot into Clockwork.
Step 7. Do a factory reset/wipe 2 times, and wipe the cache 2 times.
Step 8. Flash the ROM by going to install zip from SD card in Clockwork and finding/selecting "acs-dk28-signed.zip".
Step 9. Enjoy!
Last edited: