archive does not contain 'boot.sig'

[nikhilpatil2010]

When i was flashing my nexus 4 in fastboot mode, i got this msg

archive does not contain 'boot.sig'
archive does not contain 'recovery.sig'
archive does not contain 'system.sig'

Is is normal ?

 

[anon(847090)]

wat r u trying 2 do? flash factory image?

 

[nikhilpatil2010]

Ya I was flashing factory image

Sent from my Nexus 4 using Tapatalk 4

 

[anon(847090)]

Ya I was flashing factory image

Sent from my Nexus 4 using Tapatalk 4

at wat point r u getting the error? which command?

 

[nikhilpatil2010]

When i run flash-all.bat , in the middle of process I'll get that... But the flashing was successful.. So just wanted to know if it's a common issue

Sent from my Nexus 4 using Tapatalk 4

 

[anon(847090)]

yeah it should be fine if the flash didnt abort and show failed message.

 

[matryc]

...

 

[Ruda Oliveira]

I had the same problem too (

 

[Karim BComFree]

Done.
Even if you have "boot.sig", "recovery.sig" errors, wait few seconds and it continues.
Works great.
Thank you.

 

[pjacobs76]

Done.
Even if you have "boot.sig", "recovery.sig" errors, wait few seconds and it continues.
Works great.
Thank you.

What if it doesn't continue? I get those messages, but then the cmd window doesn't advance or show anything else. It's just sitting there. I tired to update my Nexus 7 to 4.4, but got stuck at the 4 circles, so I'm trying to go back to a previous version and start again, but this is where i'm stuck. I'm trying to flash the JWR66Y stock ROM.

 

[Leonardo Luiz]

I have the same problem, now I'm stuck on sending 'boot'

 

[someguy01234]

It's not a problem, normal behavior.

I have the same problem, now I'm stuck on sending 'boot'

It have nothing to do with this, which also is not a problem.
Your problem could be due to:
-out dated fastboot, use fastboot the latest ADT package
-incorrect driver installed
-usb port or cable issues (yes it is possible)
-corrupt image file

 

[Franckzila]

yes this is normal, wait a few minutes (10-15) but do not close the CM, and everything will continue as normal ...

 

[joseph scheidt]

im having the same problem but it says press any key to exit do i still wait?

 

[Nerio Laboratory]

sig files contain additional scripts and informations. You dont need these files.

 

[WP7Nettwerk]

Just extract those files to same folder where you have rest of files and flash one by one. Take a look Nexus 6 forum you will see more explain.

Sent from my Nexus 6 using Tapatalk

 

[Mohamed Taha Shaalan]

Just wait for minutes , that is what happened with me exatly , your computer also will freez for minutes , let it complete the update donnt inttrupt the process,