Bezel Issue

alians07

Active member
Aug 16, 2018
36
0
0
I just received my watch (46 BTE). Immediately, I noticed that bezel is quite tight. I have to have a good grip on bezel with two fingers otherwise it won't move.

Anyone else noticed something similar ?
 
I just received my watch (46 BTE). Immediately, I noticed that bezel is quite tight. I have to have a good grip on bezel with two fingers otherwise it won't move.

Anyone else noticed something similar ?

Mine feels perfectly fine. I can turn it with just 1 finger on one side of it.
 
Mine takes a little force, but I can still move it with one finger. Definatly harder than my refurbed gear s3.
 
I am going to go to T-mo and check out their demo to figure out the baseline. Thanks guys
 
I just received my watch (46 BTE). Immediately, I noticed that bezel is quite tight. I have to have a good grip on bezel with two fingers otherwise it won't move.

Anyone else noticed something similar ?

Mine was very easy to turn the first few weeks, now this week it goes from fairly hard to turn to easy and back. Very annoying.
 
Mine was very easy to turn the first few weeks, now this week it goes from fairly hard to turn to easy and back. Very annoying.

Found a solution online

"I had the same exact problem, and I simply ran it under some running water and it's back to new! Good thing the Gear S3 is extremely water resistant, I would just be careful with the temperature water you use, I used Luke warm to be safe."

This seems to have fixed mine.
 

Members online

Forum statistics

Threads
954,055
Messages
6,960,422
Members
3,162,916
Latest member
ledgersupport2025