v5.0
turned on regulators instead of vreg for ld012 (wlan) and cut them to 2.4v from 2.85v in board-thunderc-mmc and board-msm7627-regulator. Since it seems to work, I can't figure out why the thunderg was still using vreg in the board-*-mmc code. They had created the regulator code and commented it out, adding the 2.6.35 vreg stuff back in instead.
It still runs, dunno if it compensates by drawing more amps... I don't have mmarz's ammeter rig to test current draw from the battery.
added an bunch of patches for linaro 4.8 but they don't help.
messing with ami304d some more.
and I'm now going to have to post selinux-enforcing and selinux-disabled kernel binaries or just leave it enforcing until there's problems.
turned on regulators instead of vreg for ld012 (wlan) and cut them to 2.4v from 2.85v in board-thunderc-mmc and board-msm7627-regulator. Since it seems to work, I can't figure out why the thunderg was still using vreg in the board-*-mmc code. They had created the regulator code and commented it out, adding the 2.6.35 vreg stuff back in instead.
It still runs, dunno if it compensates by drawing more amps... I don't have mmarz's ammeter rig to test current draw from the battery.
added an bunch of patches for linaro 4.8 but they don't help.
messing with ami304d some more.
and I'm now going to have to post selinux-enforcing and selinux-disabled kernel binaries or just leave it enforcing until there's problems.
Last edited: