attached with usb cable

[traindrvr63]

Would like to know if anyone else has this issue......when I plug my x in with the wall charger, it works normal...no matter what I am doing on it, but if I plug it into my pc with the usb cable....it bogs down or sometimes even freezes...and i have to unhook it from my pc ... then after a few min it will work normal again.. am i missing a setting or something....thanks to all in advance.

 

[tntdroid]

Power from the wall and a pc are different. This could cause a issue. I have had this on a pc at work but my home pc has no issues.

sent by me on my X

 

[Ricky Babalu]

Did you install the "Motorola Driver"?

 

[traindrvr63]

Did you install the "Motorola Driver"?

yes.. I installed the driver.. maybe I didn't quite explain it clear enough...everything works... it's just when I have it plugged in to the computer...the screen hangs up or becomes unresponsive until i unplug it from the pc.

 

[tntdroid]

I believe its the current charging the x causing the lag. I seen it when typing while plugged in.

sent by me on my X

 

[traindrvr63]

That could be ......I tried a different usb port and works a little better.

 

[jdbower]

It also may be resyncing the SD card once you unplug it. You can try changing the USB settings on your phone to Power Only and see if that helps.

 

[greydarrah]

Typically, your phones sd card has to change over to a storage device mode when connected to the pc, so anything that might have been accessing your card, like ring tones, music (if you had a player running), or even apps, if you've installed any to the card, can not be access by the phone. It wouldn't surprise me that is causes a moment of lag while the phone re-orients itself to this.

Try hooking up and then setting the usb on your phone to Charge Only mode (I think that's what it's called), and I bet that it runs fine.

 

[doctorlove316]

It also may be resyncing the SD card once you unplug it. You can try changing the USB settings on your phone to Power Only and see if that helps.

I would try this. If all your doing with it plugged in to your PC is charging it, this should definitely help. "Charge Only"