Is SD 820 heating up? And heat sync pipe is not liquid cooled? Of s7 edge

Heat pipes don't need liquid to do their job.

Every processor will heat up with use. There is no way around that.
 
What were you expecting? Fluids to flow out? A heatpipe actually has very little fluid, if you feel it it might feel a little damp but that's about it. It's not going to gush out like a river. Look up what's inside heatpipes on google
 
What were you expecting? Fluids to flow out? A heatpipe actually has very little fluid, if you feel it it might feel a little damp but that's about it. It's not going to gush out like a river. Look up what's inside heatpipes on google

Then why would they say liquid cooling , shud hav marketed as heat-pipe or empty copper pipe
 
Who ever said the Edge would have liquid cooling in the first place???
Liquid cooling has never been shown to be needed with the Snapdragon 820 unlike the 1st generation SD 810 which did have issues so they came up with the gimmick of "liquid cooling" to pacify worriers of the first generation 810s, later versions of the SD 810 without "liquid cooling" did fine... Heat pipes do a fine job dispersing heat from the processor.
 
Samsung actually mentioned it as liquid cooling in their introduction. There is a link on xda to an article with one of the Samsung engineers. In it he mentions that the amount of liquid in the pipe is extremely small, something like .002ml and that it evaporates out immediately if the heat pipe is opened. He did go on to say that even that small amount of liquid has a big impact on cooling.
 
Who ever said the Edge would have liquid cooling in the first place???
Liquid cooling has never been shown to be needed with the Snapdragon 820 unlike the 1st generation SD 810 which did have issues so they came up with the gimmick of "liquid cooling" to pacify worriers of the first generation 810s, later versions of the SD 810 without "liquid cooling" did fine... Heat pipes do a fine job dispersing heat from the processor.
Samsung mentioned it on the announcement.
 
If u watch that video u can see the processor damaging it holdings

That appears to be the plastic doing its job. Making sure nothing else has to take the heat. The plastic isn't "holding" the chip. The motherboard is holding the chip. The plastic is a heat shield for the other components of the phone.
 
So essentially, once it's been repaired, it's no longer water tight, right?
 
The phone is not heating up at all. Snapdragon 820 is a performance beast with no heat penalty!
 
The amount of liquid can be deceiving. Where I work we have 3 IBM Z/12 mainframes (these beasts are about the size of a full size Ford Econoline van (not the mini van) standing up on their rear bumper). They are liquid cooled, they use a coolant like your car, and use about 5 gallons. While I know it is not a like for like comparison, these bad boys get HOT. you put 65 degree air in the intake and get 130 degree air out the back. But if you were to reduce them to the size of our phones, the amount of liquid would be less than a drop. I know that a drop would not exhaust heat. But I don't think these phones need much more that a method to move the heat from the processor to near the back case to do the thermal exchange.
 
Funny, at Best Buy I played with an edge7 that was uncomfortably hot to hold. I figured it is on max brightness and sales display mode and always charging so no biggie. Then I went to VZW. Played with the edge7 plugged in with display mode running just like BestBuy. It wasn't hot at all. One difference I noticed was BestBuy model running on their wifi and VZW connected to LTE. Not suggesting that means anything. Just the only thing that seemed different.
 
Then why would they say liquid cooling , shud hav marketed as heat-pipe or empty copper pipe
Id does have liquid inside the heatpipe. Ex: U boil water, when it heats up it vaporize into "gas form" and when cooled down it turns back to water.
 
Then why would they say liquid cooling , shud hav marketed as heat-pipe or empty copper pipe

Because it sounds cooler to say it than "a heatpipe".
Microsoft pulled the exact same stunt with their 950XL last October. It's a buzz word to mislead the consumer, nothing else. It's called "marketing".
 
Id does have liquid inside the heatpipe. Ex: U boil water, when it heats up it vaporize into "gas form" and when cooled down it turns back to water.

I highly doubt that the internal temp reaches anything close to boiling point for water.
 
I am jus worried if one day use made that processor mess up like that in the tear down video , i have to use it 2 years on contracts. As of my iphone i changed it apple store when ever i got an issue . They would jus take mine and gives me a another phones . I highly doubt samsung gonna be so aggressive about customer service.
 
I am jus worried if one day use made that processor mess up like that in the tear down video , i have to use it 2 years on contracts. As of my iphone i changed it apple store when ever i got an issue . They would jus take mine and gives me a another phones . I highly doubt samsung gonna be so aggressive about customer service.

As I said before, I'm pretty sure what you're seeing is not damage. I'm almost certain it's a plastic heat shield doing its job, which is to stop the heat from affecting the components that are close to the chip as much as possible.

I wouldn't be too worried. I'm sure if the chip were to damage itself so easily Samsung would already know about it and would have designed around it, fixed the problem, or not used that particular chip.
 

Trending Posts

Forum statistics

Threads
956,900
Messages
6,970,515
Members
3,163,643
Latest member
stonefruit