I have mine on a leather back
Posted via Android Central App
I bought a Qi nfc sticker on Amazon and so far it's working fine.
Posted via Android Central App
I snagged a Quick Circle case and it works with Qi on my AT&T G4. There were some concerns about it being PMA only, this is not true. Qi working fine!
View attachment 181872
The contacts are not fitting snugly. I had to place 2 little pieces of electrical tape under each pad under the contacts area and then it connects reliably. There just isn't enough constant pressure without raising up the sticker contacts a bit. A few of us have had this happen. Give it a try.
Nice. Maybe it does both and just depends on which back you get?
I snagged a Quick Circle case and it works with Qi on my AT&T G4. There were some concerns about it being PMA only, this is not true. Qi working fine!
View attachment 181872
That is very good news for the many of AT&T owners out there.
I would create a new thread, this information may get lost in this thread.
Again, thanks for posting!
Where did you get it at?
Posted via the Android Central App
Provided that you are not on AT&T.
I bought the Same style sticker and am having no luck with my 2 Qi chargers : 1 flat the other a slanted stand.
One thing I noticed on the Quick Circle case was that Both connectors are on a Small Raised Surface : a little bump where the 2 gold chargers should lay on. Otherwise, the arched back won't allow for a "contact" or connection (?). The Leather cases only have the Raised Bump on the middle left side. The top right is a flat surface. I'm guessing the NFC is the 2 gold connectors in the middle left and the 2 gold connectors we Need are on the upper right (as looking at the back plate.) but it's a FLAT surface basically leaving us without Qi charging for NOW. As more OEM back plates become available I'll be looking for that Raised spot on the upper right side.
Also ... are there 4 connectors on the middle left with 2 of them covered???
ANY suggestions are helpful.
Thanks,
liveTexas
The contacts are not fitting snugly. I had to place 2 little pieces of electrical tape under each pad under the contacts area and then it connects reliably. There just isn't enough constant pressure without raising up the sticker contacts a bit. A few of us have had this happen. Give it a try.
I'm about to buy and test this one from china. Sticker and pad for $8 shipped. Hope it doesn't blow up my G4 lol
http://www.amazon.com/gp/aw/d/B00ZF...ag=hawk-future-20&ascsubtag=UUacUvbUpU4504520