Z Fold 7 Cases

[theshaz]

Looking for a thin case that does cover the hinge, but I don't want anything on the screen. Haven't had anything on my last four Sammy flagship S series phones. Also want magsafe. My regular charge stand in the office needs to get replaced. The back of the charger is too high and hits the camera lenses. Also I want to have the phone open. Magsafe can hold the phone in position even if opened up.

 

[donm527]

Looking for a thin case that does cover the hinge, but I don't want anything on the screen. Haven't had anything on my last four Sammy flagship S series phones. Also want magsafe. My regular charge stand in the office needs to get replaced. The back of the charger is too high and hits the camera lenses. Also I want to have the phone open. Magsafe can hold the phone in position even if opened up.

Probably best you can do currently is buy a full set and not use the front cover. Just got to find one where the hinge is not too bulky along with thin case. I think the one below would fit the bill best.

I don't want a bulky case to take away of the engineering put in to make this thing so thin and would like to rock it as thin as my S23U with a think LaterCase on it.

Being a first time Fold owner I am a bit concerned on how dust/water resistant this thing will be. There is probably a ton of engineering I don't know about that hopefully makes this a non issue but I 100% pocket carry I'd really like hinge protection just to keep lint and debris from possibility working its way into the hinge gap when carrying in pockets.

But I've decided to go with Pitaka and see how that works out. Hopefully after a couple of months of carrying I'll see it's a not a big deal. If I see lint and debris start building up at the hinges and having to constantly wipe the area clean, then I may have to think of other case for peace of mind.

Amazon.com: BENKS for Samsung Galaxy Z Fold 7 Case with Screen Protector, MagSafe-Compatible Kevlar Case, Hinge Protection Shockproof Magnetic Phone Case for Z Fold 7, Aurora ArmorAir Grand Combo : Cell Phones & Accessories

Amazon.com: BENKS for Samsung Galaxy Z Fold 7 Case with Screen Protector, MagSafe-Compatible Kevlar Case, Hinge Protection Shockproof Magnetic Phone Case for Z Fold 7, Aurora ArmorAir Grand Combo : Cell Phones & Accessories

www.amazon.com

 

[Mike Dee]

Probably best you can do currently is buy a full set and not use the front cover. Just got to find one where the hinge is not too bulky along with thin case. I think the one below would fit the bill best.

I don't want a bulky case to take away of the engineering put in to make this thing so thin and would like to rock it as thin as my S23U with a think LaterCase on it.

Being a first time Fold owner I am a bit concerned on how dust/water resistant this thing will be. There is probably a ton of engineering I don't know about that hopefully makes this a non issue but I 100% pocket carry I'd really like hinge protection just to keep lint and debris from possibility working its way into the hinge gap when carrying in pockets.

But I've decided to go with Pitaka and see how that works out. Hopefully after a couple of months of carrying I'll see it's a not a big deal. If I see lint and debris start building up at the hinges and having to constantly wipe the area clean, then I may have to think of other case for peace of mind.

Amazon.com: BENKS for Samsung Galaxy Z Fold 7 Case with Screen Protector, MagSafe-Compatible Kevlar Case, Hinge Protection Shockproof Magnetic Phone Case for Z Fold 7, Aurora ArmorAir Grand Combo : Cell Phones & Accessories

Amazon.com: BENKS for Samsung Galaxy Z Fold 7 Case with Screen Protector, MagSafe-Compatible Kevlar Case, Hinge Protection Shockproof Magnetic Phone Case for Z Fold 7, Aurora ArmorAir Grand Combo : Cell Phones & Accessories

www.amazon.com

With regard to the hinge I never had a problem with the 3,4,5, or 6, however I am typically not in a dusty environment and I don't think I ever used at the beach. I don't think sand is trouble for the hinge as much as it might damage the display by folding it with sand on the screen.

 

[mlblack16]

Looking for a thin case that does cover the hinge, but I don't want anything on the screen. Haven't had anything on my last four Sammy flagship S series phones. Also want magsafe. My regular charge stand in the office needs to get replaced. The back of the charger is too high and hits the camera lenses. Also I want to have the phone open. Magsafe can hold the phone in position even if opened up.

Same and that's why I think I'm going with this one:

[Grand Combo] Aurora ArmorAir Case built with Kevlar® for Samsung Galaxy Z Fold 7

Protect your Galaxy Z Fold 7 with a MagSafe-compatible case made of aramid fiber. Offers strong magnetic hold, durable hinge protection, and a slim, fold-ready fit.

www.benks.com

I'm going to need to mortgage the house to pay for it but I think it's the most slim case I've seen yet that covers front frame, has strong magnet for magsafe and covers the hinge. Oh, and it has that Pitaka look that I really like. The only downside is covering the appearance of the phone itself.

Some may say the hinge doesn't need protection and maybe that's true, but it's just as much about having something to smooth out the feel when holding the Fold closed. I can't stand the sharp edges and it doesn't look as consistent in design.

 

[mlblack16]

They must be out of stock and holding off on freebees

I've not heard back either, but also not certain I would use that one anyway. I've used his cases through the years, starting with the S20U and I do think the quality has improved quite a bit.

 

[theshaz]

With regard to the hinge I never had a problem with the 3,4,5, or 6, however I am typically not in a dusty environment and I don't think I ever used at the beach. I don't think sand is trouble for the hinge as much as it might damage the display by folding it with sand on the screen.

I'm in Florida. I told myself that if I went to the beach, the phone stays closed. Sand could damage the screen when folded. It makes such a nice snap when you close it.

 

[theshaz]

Thanks for the case recommendations. I had to give my wife my left testicle to get this phone. Hate to have to give the other one for a case.

Might have to settle for a good or decent one until the prices drop.

$40-50 Premium
$30-40 Good
$20-30 Decent
$10-20 OK
UNDER $10 Cheap

 

[cuzlion]

Currently there is no Fold 7 case with hinge protection that will work with any existing mag safe battery pack. Zero, nada, zilch. And, in fact, it's virtually impossible to design one. The solution lies with the battery pack manufacturers. They could easily make a battery pack with a rounded top that doesn't extend past the magnet ring. And I expect one is already in the works. Every single mag safe battery pack was designed for iPhones, which have a huge clearance between the cameras and the magnets. Why Samsung put them so close to each other is a mystery.

 

[mlblack16]

Currently there is no Fold 7 case with hinge protection that will work with any existing mag safe battery pack. Zero, nada, zilch. And, in fact, it's virtually impossible to design one. The solution lies with the battery pack manufacturers. They could easily make a battery pack with a rounded top that doesn't extend past the magnet ring. And I expect one is already in the works. Every single mag safe battery pack was designed for iPhones, which have a huge clearance between the cameras and the magnets. Why Samsung put them so close to each other is a mystery.

There's actually plenty of battery pack options but the design issue might be more related to when the Fold is open and the hinge protector is covering part of the phone between magnet and hinge protector.

If you go to the 9:35 Mark on this video you'll see some options that do not hit the camera lenses.

 

[ClintRo]

Pitaka blue case arrived. The battery banks still work but they sit crooked due to the camera bump.

Fits very tight but no front rail.

 

[ClintRo]

Side view

 

[donm527]

Pitaka blue case arrived. The battery banks still work but they sit crooked due to the camera bump.

Fits very tight but no front rail.

Very nice. I just got my ship confirmation email from Pitaka so looks like coming from China so hope I get mine by end of week.

You need to show pics without the battery pack I was afraid the battery pack won't fit straight but I guess as long as it can works rotated. :/

The lines look very tight and close along the edges of the case. In the Flossy video it looked like it fit very snugly into place and said probably didn't need to use the tap along the hinge where on other cases I've seen videos where if you don't use the tape, the side along the hinge will lift when pulling a magsafe device off the back.

Did you secure your case with the tape?

 

[theshaz]

Got this today at the flea market. I was suprised they had any for the Z.Fold 7?

$13, tbis will hold me over until I find the case I want. I lost the ability to charge via wireless. But drop protection was more important, naked this phone is like holding wet ice. Doesn't add too much bulk. Again, $13, what do you expect?

I will wait a bit for the good cases to drop in price and legit reviews after people spend some time with them.

No screen protection, my last 3 or 4 Sammy phones I didn't use a screen protector. My S24 Ultra doesn't have one and the screen is pristine. I just needed drop protection for the corners.

 

[SouthFloridaEd]

Hello everyone. I used to be here years ago. I bought Z-Fold 7 and as much as I don't like cases, I always use one for safety. I bought a cheap on on Amazon and the problem I'm having is that the power/fingerprint button is recessed and with the case it's not easy to unlock when the phone is closed. I bought a magnetic ring from ESR, but their car charge magnet is so strong it pulls the ring off. They said the rings are designed primarily for cases.

Does anyone currently own a case where the power button/fingerprint button cutout makes it easy to unlock?

 

[racedog]

Hello everyone. I used to be here years ago. I bought Z-Fold 7
Does anyone currently own a case where the power button/fingerprint button cutout makes it easy to unlock?

I had the same problem. Here is the one I'm using now and it doesn't have the button issue. It is pricey but it works well. However, it is a tad more slippery than I would like but not excessively so.

Amazon.com: kaisenkec Slim and Thin Carbon Fiber Case Compatible with Samsung Galaxy Z Fold 7, 600D Aramid Fiber Z Fold7 Cover Compatible with Magsafe, Matte Black Gray Twill [NOT Printed] : Cell Phones & Accessories

Buy kaisenkec Slim and Thin Carbon Fiber Case Compatible with Samsung Galaxy Z Fold 7, 600D Aramid Fiber Z Fold7 Cover Compatible with Magsafe, Matte Black Gray Twill [NOT Printed]: Basic Cases - Amazon.com ✓ FREE DELIVERY possible on eligible purchases

www.amazon.com

 

[bhatech]

Samsung Clear case with MagSafe. Nice minimal case with MagSafe, had Samsung rewards points so got this case. Otherwise, would have got something from Amazon.

 

[racedog]

Does that Samsung Clear Case have both a cover for the bottom and top? I only see one cover and it looks like your top screen (and body) are unprotected.

The aramid case has both and includes two sided strips to hold the cases (both top and bottom) in place without moving. They work but I found them hard to work with until I got the hang of it.

 

[bhatech]

Does that Samsung Clear Case have both a cover for the bottom and top? I only see one cover and it looks like your top screen (and body) are unprotected.

The aramid case has both and includes two sided strips to hold the cases (both top and bottom) in place without moving. They work but I found them hard to work with until I got the hang of it.

Not sure I understand which top and bottom you are referring to, but the clear case is just a back case and covers all sides except the hinge. It doesn't have a front case, like all other official Samsung cases. Instead, it just comes with an anti-glare screen protector, but I already have a glass screen protector applied.

 

[Bkdodger1]

I've been very happy with the Thinborne case with the for not moving around and so thin I feel like the phone is naked. Power button feel is better now with it on and my muscle memory.