Took The Back Off Before Returning It For The Bad Door!!

[AndroidXTC]

I know, I should have taken pictures but if you ever want to remove the back its easy breezy. All you do is where the volume buttons are stick your finger nail in between the case back and the housing there is a snap there. Once that snap lets go take a credit card wedge it in there and just advance it around the housing releasing all the snaps. The back is SUPER FLEXIBLE. The housing back is glued to the battery by a re usable sticky tape applied to the battery itself. You have to pull it off the tape really slowly. The battery also appears to be taped to the board below it. I didn't try to remove it.

 

[golgotha]

Good to know. Thanks. Fyi this voids your warranty.

 

[cr2]

Here are directions on how to completely disassemble the phone:

Motorola Droid RAZR Takeapart, Teardown & Repair Directions | DirectFix - YouTube

And here is re-assembly:

Motorola Droid RAZR Reassembly Directions | DirectFix - YouTube

Have fun! )

 

[AndroidXTC]

Good to know. Thanks. Fyi this voids your warranty.

There is no way they will know if the back is removed or not, there is no seal or anything. There is a water indicator in the power switch area however.

 

[FredBassett]

Oh they will

 

[TrendyProfessional1]

Oh they will

They aint gonna check.......................

 

[cbreze]

That vid is for the razr, no? Not the maxx? I was wanting to see how the bigg battery was installed and still so thin.

 

[AndroidXTC]

The way they kept it thin was with the Kevlar backing its paper thin. This is why the back is glued to the battery otherwise it would bow or flex to much. Its a tight sandwich one component glued to the other. This phone is almost case less.