powerbird101
New member
- May 19, 2010
- 4
- 0
- 0
Message to Everyone with a EVO 4G LTE: There have been 2 primary issues relating to the proximity sensor. The 1st and most common is the fact that the ZAGG InvisibleShield is not cut out properly (top left cutout is not wide enough). Now the 2nd issue i have found after finding a few with a hardware defect directly relating to the proximity sensor itself. This is usually solved by swapping the device out. Others have seen some issues with the corner of the screen being raised (again hardware defect). This is similar to the original EVO 4G release where some phones had rising screens on the bottom along with heavy light bleeding. Now I can almost gurantee there are other issues as well but this is what I have found so far in within the small community of EVO 4G LTE owners with proximity issues.
ZAGG is also aware of this issue at hand and will be modifying the new cutout within the next week or so. Date obviously is not specified when.
ZAGG is also aware of this issue at hand and will be modifying the new cutout within the next week or so. Date obviously is not specified when.
Last edited: