F34R
F34RTEHDR01D
Re: [ROM][Repost][06/05/11] Comm ROM 2.1 (UKB) from TSM **Updated
Ahh... I knew it was somewhere. Thanks. That helps a TON.
Ahh... I knew it was somewhere. Thanks. That helps a TON.
How long should it take to reboot after loading ukb 2.0? I loaded the non kernel file through CWM all 3_30 and then without rebooting I loaded the ukb 2.1 patch then rebooted. It was stuck on the android screen in a loop for over 30 minutes. I had to pull the battery and boot into CWM and restore the NAND backup I made before I started the process. Should it take longer then 30 minutes to boot and am I just impatient and I should have waited longer? Has this happened to anyone before? I?m not sure if it was because I used CWM all 3_30 which is CWM 2.5 and I should have used CWM 3.0. The OP says to use CWM 3.0 but 2.5 did work for testers. Any help or advice would be greatly appreciated. I am currently running superclean 2.9.2 with comavolt non voodoo kernel and EC09 modem.
I let it boot completely into UKB 2.0 then went back into recovery and installed the 2.1 patch. Did not have any problems. Used CWM 3.0.
Do you recall how long it took to boot after installing UKB 2.0?
I finally leapt from SC 2.9.2, does this 2.1 ukb have a dummy tether?
I finally leapt from SC 2.9.2, does this 2.1 ukb have a dummy tether?