Hockeypuck55
Well-known member
- Feb 2, 2011
- 108
- 3
- 0
echo * Unplug the USB cable from your computer. (if you don't, that's okay,
echo * you'll just see Windows pop up some errors as you continue below.)
echo * Bootloader will be highlighted in blue - Press the power button to execute.
echo * The screen will change and Fastboot will be selected.Around 10sec later
echo * it will then proceed to the next step.
echo * You should see several files loaded and checked.Don't freak at the warnings.
echo * The screen will eventually clear and you will see "checking pd05img.zip."
echo * Eventually, you will be asked: Do you want to start update?
echo * Press the volume up button to say yes.
echo * Once you do, you will see a progress bar in the upper right corner
echo * and a bunch of stuff going on in the middle.Patient and let it do its thing.
echo * Press power to reboot.
echo * Once Sense is booted up, unlock your screen to enter the setup wizard.
echo * Hit Next - Skip - Skip Setup - Next - Next - Next - Finish
echo * Then hit the menu capacitive button
echo * settings - applications - development - check USB debugging - then click Ok
echo * Plug the Thunderbolt into your computer.
echo * Swipe down on notification panel.
echo * Make sure its in "Charge Only" mode, if not select it and hit done
echo * If all above conditions
Yes this is where I slipped up when I was doing it last night. The step after this when I think it was deleting things.